34322 Data Path Control DPC: SCSI asynchronous transfer requested, line <Line Number> Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 An attempt was made by the workstation to transfer image data with asynchronous SCSI transfers. The SCSI drivers installed on the workstation should be checked for correct revision, etc. If the error persists, the line number reported should be recorded and the responsible firmware programmer contacted. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Incorrect or corrupted SCSI drivers on workstation. Line Number The parameter in the error string is used to specify the line number within the SCSI driver code where the error was detected. This information is useful to the firmware developer when trying to diagnose this problem. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:03 2008 PST